The actual angle will include degrees (D), minutes (â), and seconds (â) and must include the appropriate symbols after the number.The bearing will always begin and end with a direction â N,E,S, or W.Next comes the If this is the case, the boundary will need to be scaled up 12 times after it is drawn. If the AutoCAD drawing being used is a typical architectural drawing where 1 unit = 1 foot, then the boundary is actually being entered in inches instead of feet.Civil engineering drawings generally utilize 1 unit = 1 foot, whereas architectural drawings generally utilize 1 unit = 1 inch.utilized to enter the survey metes and bounds information. Boundaries are nearly always shown in decimal distances representing feet. attribute(s) in the assessor database that will allow the joining and relating of the parcels.The distance is entered in units with no feet or inch notations being entered.Enter the sign first, which means that it is relative to the last point.The syntax for the relative polar coordinate and angle is as follows:.Use the LINE command or the PLINE command to start drafting the boundary, and utilizing relative polar coordinates to specify the points.Pick the OK button to exit the Drawing Units dialog box.Pick the OK button to exit the Direction Control dialog box.In the Direction Control dialog box, select the East option for Base Angle.Make sure that there is NOT a checkmark next to the Clockwise option.In the Angle Precision list box, select the desired precision level which is typically N 0d00â00â E.In the Angle Type list box, select Surveyorâs Units. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |